Xterra XE 4WD V6-3.3L SC (VG33ER) (2002)
![background image](/nissan/xterra_xe_4wd/v6-3.3l_sc_(vg33er)/Page-1770001.png)
Torsion Bar: Service and Repair
REMOVAL
1. Move dust cover.
2. Paint matching marks on the torsion bar spring and the corresponding arm.
Always use paint to place the matching mark; do not scribe the affected parts.
3. Measure anchor bolt protrusion "L" and remove the lock nut and adjusting nut.
Standard length "L" = 68 mm (2.68 inch)
Before removing the nuts, ensure that twisting force is eliminated from the torsion bar springs.
4. Remove torsion bar spring.
^
Remove torque arm fixing nuts, then withdraw torsion bar spring forward with torque arm.
INSPECTION
^
Check torsion bar spring for wear, twist, bend and other damage.
^
Check serrations of each part for cracks, wear, twist and other damage.
^
Check dust cover for cracks.
INSTALLATION AND ADJUSTMENT