Xterra XE 4WD V6-3.3L SC (VG33ER) (2002)
4.
Apply some Nissan Brake Cleaner to a clean, lint-free shop rag and clean the ABS sensor mounting surface (see Figure C3)
NOTE:
If needed, clean the flange/O-ring sealing surface on the axle housing with a wire brush ONLY.
5.
Return to the "Repair Flow Chart" for further instructions.
Procedure D: Axle Shaft Re-Assembly
Requires: Axle Grease Seal Kit P/N 43252-0W025
1.
Install the new axle shaft seal in the axle housing (see Figure D1):
^
Use "Seal Installer (Inner)" special tool # J-341 15 to install the seal.
^
Make sure the seal is fully seated in the axle housing and the face of the seal is facing outwards.