Achieva L4-144 2.4L DOHC VIN T SFI (1996)
Accelerator Pedal: Service and Repair
Accelerator Pedal Assembly
REMOVE OR DISCONNECT
1. Remove left sound insulator.
2. Remove the release cable (1) retainer from lever assembly.
3. Remove the nuts to cowl.
4. Remove the pedal assembly (2).
INSTALL OR CONNECT
1. Install the pedal assembly (2) to cowl.
2. Install the nuts to cowl.
-
Tighten the nuts to 30 Nm (25 lb. ft.).
3. Slip accelerator cable (1) through slot in rod and then install retainer in rod, being sure it is seated.
4. Install the left sound insulator.
NOTE: Flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2.0 in.) of moving parts of accelerator linkage
outboard of support unless routing is positively controlled.
5. Check for correct opening and closing positions by operating accelerator pedal. Make sure that the throttle valve reaches wideopen throttle
position. If it does not, inspect for damaged or bent brackets, levers, or other components; or, for poor carpet in under the accelerator pedal.
