Achieva V6-3100 3.1L MFI VIN M (1994)
Power Door Lock Switch: Initial Inspection and Diagnostic Overview
System Check
System Diagnosis
SYSTEM DIAGNOSIS
^
Perform the System Check and refer to the Symptom Table for the appropriate diagnostic procedures.
Troubleshooting Hints
TROUBLESHOOTING HINTS (Perform before beginning System Diagnosis)
1. Check DR LK Fuse.
2. Check CTSY Fuse by operating the I/P Compartment Light.
3. Check DR UNLK Fuse.
4. Check for mechanical binds in the Door Lock System.
5. If one or more of the Door Lock Motors do not operate properly but the other Door Lock Motors function normally, check the wiring to the
motors. If the wiring is OK, replace the motor.
6. If CTSY Fuse blows when a power Door Lock Switch is activated, check CKT 194, CKT 195 and Multi-function Alarm Module for a short to
ground.
7. If a motor's internal circuit breaker trips, it will not reset until voltage is removed from the motor.
8. If the Door Lock Fuse blows when a Power Door Lock Switch is activated, check CKT 295 and CKT 294 for a short to ground.
9. If Electronic PRNDL does not operate, see Computers and Control Systems/Transmission Position Switch/Sensor.
10. If LH Front Door Lock is the only inoperative lock, and the vehicle is equipped with the Keyless Entry Feature, see Keyless Entry.
NOTE:
^
Automatic Door Lock feature is controlled by the Multi-function Alarm Module. Verify that all chime alarms operate and that the Illuminated
Entry feature operates before diagnosing any Automatic Door Lock problems.
^
Refer to System Diagnosis.