Achieva V6-3300 3.3L (1992)
4.
Fuel rail assembly.
DISASSEMBLE:
1.
Injector retainer clip and discard.
2.
MPFI injector assembly.
3.
Injector O-ring seals from both ends of injector and discard.
IMPORTANT: Each injector is calibrated for a specific flow rate. When replacing fuel injectors, order replacements with the identical part number as
the old injectors.
ASSEMBLE:
1.
Lubricate new injector O-ring seals with clean engine oil, and install on injector assembly.
2.
New injector retainer clips on injector assembly. Position open end of clip facing injector electrical connector.
3.
MPFI injector assembly into fuel rail injector socket with electrical connectors facing outward. Push in far enough to engage retainer clip with
machined slots on rail socket.
INSTALL OR CONNECT:
1.
Fuel rail assembly.
2.
Intake manifold plenum.
Injector Part Number Location
Injector Installation
IDLE LEARN PROCEDURE: Any time the battery is disconnected, the programmed position of the IAC valve pintle is lost, and replaced with a
default value. To return the IAC valve pintle to the correct position, perform the following procedure:
