Alero L4-144 2.4L DOHC VIN T SFI (2000)
14. Install the bolts which secure the fuel rail to the camshaft housing.
^
Tighten the camshaft housing bolts to 26 Nm (19 ft. lbs.).
15. Install the fuel line retaining clamp and the retainer to the bracket on top of the camshaft housing.
16. Install the vacuum line to the fuel pressure regulator.
17. Install the fuel injector harness connector.
18. Install the camshaft position sensor connector.
Important: When reinstalling the power steering pump, apply a 3 mm (1/4 inch) bead of GM P/N 12346286 sealer or the equivalent to the joint
at the end of the camshaft housing halves before the installation of the power steering pump and the pump face seal.
19. Install the power steering pump assembly.
20. If any spark plug boot connector assembly has stuck to a spark plug, reinstall the connector onto the ignition coil and the module assembly.