Alero L4-144 2.4L DOHC VIN T SFI (2000)
7. Install the new seals between the camshaft housing and the orange camshaft housing cover.
Sealer is unnecessary.
8. Remove the bolt holding the housing in place.
9. Apply pipe sealant GM P/N 1052080 or the equivalent to the camshaft housing and to the threads of the cover retaining bolt.
10. Install the cover to the camshaft housing.
Notice: Refer to Fastener Notice in Service Precautions.
11. Use the J 36660-A in order to install the bolts.
^
Tighten the bolts which secure the camshaft housing to the cylinder head to 15 Nm (11 ft. lbs.) + 90 degrees.
^
Tighten the bolts which secure the camshaft housing cover to the camshaft housing to 15 Nm (11 ft. lbs.) + 30 degrees.
12. Install the timing chain housing to the camshaft housing and the timing chain. Refer to Timing Chain Housing Replacement.
13. Install the exhaust camshaft housing cover and the new gasket.
14. Connect the electrical connection to the oil pressure switch.
15. If any spark plug boot connector assembly is stuck to a spark plug, reinstall the connector onto the ignition coil and the module assembly.
