Alero L4-144 2.4L DOHC VIN T SFI (2000)
Balance Shaft: Service and Repair
Balance Shaft Housing Installation
Balance Shaft Housing Installation
Tools Required:
-
J 41088 Balance Shaft Holder
-
J 36660-A Torque Angle Meter
1. Install the balance shaft assembly to the block. Use Loctite (R) 272 GM P/N 12345493 on the housing assembly to the block bolts.
2. If the balance shaft housing was disassembled, loosely assemble the housing assembly to the block.
Notice: Refer to Fastener Notice in Service Precautions.
3. Tighten the housing fasteners in sequence.
^
Tighten fasteners 1, 2, 4, 5, 6 and 7 to 15 Nm (11 ft. lbs.) + 40 degrees.
^
Tighten fasteners 3 and 8 to 10 Nm (89 inch lbs.) + 40 degrees.