Alero L4-144 2.4L DOHC VIN T SFI (2000)
11. Remove and discard the O-ring seal.
12. Remove the block fitting bolt at the rear head of the compressor (2.4L shown).
13. Remove the compressor hose assembly from the compressor.
14. Remove and discard the sealing washer.
INSTALLATION PROCEDURE
1. Position the compressor hose assembly.
2. Install NEW sealing washers at the compressor ports.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the block fitting and the bolt to the rear head of the compressor.
Tighten
Tighten the block fitting bolt to 33 N.m (24 lb ft).