Aurora V6-214 3.5L VIN H SFI (2001)
1. Install the rear shelf trim panel carrier into the vehicle.
2. Connect the electrical connector.
3. Install the fasteners in order to secure the carrier.
Notice: Refer to Fastener Notice in Cautions and Notices.
Tighten the fasteners to 9 Nm (80 lb in).
4. Install the rear shelf trim panel. Refer to Rear Window Shelf Trim Panel Replacement (See: Rear Shelf/Service and Repair/Rear Window Shelf
Trim Panel Replacement).
Rear Window Shelf Trim Panel Replacement
Rear Window Shelf Trim Panel Replacement
Removal Procedure
1. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement (See: Seats/Seat Cushion/Service and Repair/Rear Seat Cushion
Replacement) in Seats.
2. Remove the rear seat back. Refer to Rear Seat Back Cushion Replacement (See: Seats/Seat Cushion/Service and Repair/Rear Seat Back Cushion
Replacement) in Seats.
3. Remove the push fasteners at the front of the rear window trim panel.
4. Remove the outer shoulder belts (2) from the trim panel (1).
5. If equipped with center shoulder belt, remove the escutcheon from the trim panel.
6. Feed the center shoulder belt and escutcheon through the hole in the trim panel.
7. Remove the rear window trim panel (1) from the vehicle.
Installation Procedure