Aurora V6-214 3.5L VIN H SFI (2001)
Rear Door Weatherstrip: Service and Repair
Rear Side Door Upper Auxiliary Weatherstrip Replacement
Rear Side Door Upper Auxiliary Weatherstrip Replacement
Removal Procedure
1. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement See: Doors, Hood and Trunk/Doors/Rear Door/Rear Door
Panel/Service and Repair
2. Remove the door control module. Refer to Door Control Module Replacement (See: Locks/Door Locks/Door Module/Service and Repair).
3. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement (See: Doors, Hood and Trunk/Doors/Rear Door/Rear Door
Panel/Service and Repair).
4. Remove the energy absorber pad. Refer to Rear Door Energy Absorber Pad Replacement (See: Doors, Hood and Trunk/Doors/Rear Door/Rear
Door Panel/Service and Repair/Energy Absorber Pad Replacement).
5. Remove the window inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement (See: Rear Side Door Window
Inner Sealing Strip Replacement).
6. Remove the window outer belt sealing strip. Refer to Rear Side Door Window Outer Sealing Strip Replacement (See: Rear Side Door Window
Outer Sealing Strip Replacement).
7. Remove the rear door window. Refer to Rear Side Door Window Replacement (See: Doors, Hood and Trunk/Doors/Rear Door/Rear Door
Window Glass/Service and Repair).
8. Remove the rear door window weatherstrip. Refer to Rear Side Door Window Weatherstrip Replacement (See: Rear Door Window Glass
Weatherstrip/Service and Repair).
9. Remove the rear door upper auxiliary weatherstrip screws (1-7).
10. Carefully pull the auxiliary weatherstrip away from the door header.
Installation Procedure
1. Seat the top of the seal lip over the door header flange.
2. Align the front hole in the weatherstrip to the plastic nut in the door header.
3. Starting at the front, roll the weatherstrip over the flange on the door header while holding the weatherstrip lip to prevent tucking under against
door.
4. Install the door to door seal on to the forward flange of the door header starting at the top and working towards the bottom.
5. Ensure the front screw hole is aligned with the plastic nut in the door header.
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Install the auxiliary weatherstrip screws (1-7).