Aurora V6-214 3.5L VIN H SFI (2001)
Cruise Control Switch: Service and Repair
Cruise Release Switch Replacement
REMOVAL PROCEDURE
1. Remove the left insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges and Warning Indicators.
2. Twist the cruise control release switch (5) counter-clockwise and remove from the bracket (1).
3. Disconnect the electrical connector from the cruise control release switch (5).
INSTALLATION PROCEDURE
IMPORTANT: When installing the brake pedal switches it is very important that the brake pedal remain in the full up or at rest position or damage
to the brake system and or switch misadjustment may occur.
1. Connect the electrical connector to the cruise control release switch (5).
2. Install the cruise control release switch (5) into the opening in the bracket (1).
3. Turn the cruise control release switch clockwise until the switch connector is at the 6 o'clock position.
IMPORTANT: The release switch assembly and the stoplamp switch assembly cannot be adjusted until after the brake booster pushrod is assembled
to brake pedal assembly. Incorrect adjustment could cause the cruise control system to not work properly.
4. Adjust the switch. Refer to Cruise Control Cable Adjustment (W/L47) or Cruise Control Cable Adjustment (W/LX5).
5. Install the left insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges and Warning Indicators.
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID".
See: Application and ID/RPO Codes
