Aurora V6-214 3.5L VIN H SFI (2001)
Compression Check: Testing and Inspection
Engine Compression Test
A compression pressure test of the engine cylinders determines the condition of the rings, the valves and the head gasket.
1. Run the engine until it reaches normal operating temperature. The battery must be at or near full charge.
2. Turn the engine OFF.
Important: Remove the Powertrain Control Module (PCM) and the ignition fuse from the IP fuse block.
3. Disable the ignition.
4. Disable the fuel systems.
5. Remove the spark plugs from all cylinders.
6. Remove the air duct from the throttle body.
7. Block the throttle plate in open position.
8. Measure the engine compression, using the following procedure:
8.1.
Install the compression gauge firmly to the spark plug hole.
8.2.
Have an assistant crank the engine through, at least four compression strokes, in the testing cylinder.
8.3.
Check and record the readings on the gauge at each stroke.
8.4.
Disconnect the gauge.
8.5.
Repeat the compression test for each cylinder.
9. Record the compression readings from all of the cylinders.
^
The lowest reading should not be less than 70 percent of the highest reading.
^
No cylinder reading should be less than 965 kPa (140 psi).
10. The following are examples of measurement problems:
^
When the compression measurement is normal, the compression builds up quickly and evenly to specified compression on each cylinder
^
When low compression is caused by the piston rings, compression is low on the first stroke and tends to build up on the following strokes, but
does not reach normal. Compression improves considerably with the addition of oil. Use approximately three squirts of oil from a plunger-type
oiler.
^
When low compression is caused by the valves, the measurement is low on the first stroke and does not build up even with the addition of oil.
^
Leaking head gaskets will provide the same results as worn valves but engine coolant may be identified in the crankcase. In addition, a leaking
head gasket will give low readings on paired cylinders.
11. Remove the block from the throttle plate.
12. Install the air duct to the throttle body.
13. Install the spark plugs.
14. Install the Powertrain Control Module (PCM).
15. Install the ignition fuses to the IP fuse block.
