Aurora V6-214 3.5L VIN H SFI (2001)
Oil Level Warning Indicator: Service and Repair
ENGINE OIL LEVEL SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Raise the vehicle.
2. Drain the engine oil.
3. Disconnect the electrical connector from engine oil level sensor.
4. Remove the engine oil level sensor from the oil pan.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the engine oil level sensor.
Tighten
Tighten the engine oil level sensor to 34 N.m (25 lb ft).
2. Lower the vehicle.
3. Add the engine oil to the correct level. For the crankcase oil capacity, refer to Capacities - Approximate Fluid in Maintenance and Lubrication.
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID".
