Aurora V6-214 3.5L VIN H SFI (2001)
The scan tool displays -40 to 150°C (40 to 300 °F). The output of the RH A/C duct temperature sensor.
Right AC Duct Temp-Open/Short Data
The scan tool displays 0 to 255 counts (0 to 5 volts). The status of the sensor signal circuit is monitored. 0 counts indicates a short to ground, 255 counts
indicates an open circuit.
Right Duct Temp Desired
The scan tool displays 18 to 120°C (0 to 250 °F). The target RH A/C duct temperature that the HVAC system is trying to achieve.
Right Htr. Duct Temp-Open/Short Data
The scan tool displays 0 to 255 counts (0 to 5 volts). The status of the sensor signal circuit is monitored. 0 counts indicates a short to ground, 255 counts
indicates an open circuit.
Right Htr.Duct Temp-HVAC Sensors
The scan tool displays -40 to 150°C (-40 to 300° F). The output of the RH HTR duct temperature sensor.
Right Program Number
The scan tool displays 0 to 255 counts. Display indicates the commanded temperature setting.
Right Solar
The scan tool displays 0 to 50 counts. The solar load output of the RH sunload sensor and ambient light sensor.
Right Solar Sensor
The scan tool displays 0 to 50 counts. The status of the sensor signal circuit is monitored. 0 counts indicates a short to ground, 255 counts indicates an
open circuit.
Right Temp Dr Actual
The scan tool displays 0 to 255 counts (0 to 5 volts). Display indicates the signal output from the feedback pot on the actuator.
Right Temp. Dr. Commanded
The scan tool displays 0 to 255 counts (0 to 5 volts). Display indicates the desired position of the actuator.
Rt. Rear Door Jamb Sw.
The scan tool displays On/off - Display indicates the state of the right rear door jamb switch. On indicates the door is open and off indicates the door is
closed.
Run/Crank
The scan tool displays Active/Inactive. The scan tool displays Active when the Crank/Run circuit of the RIM receives a battery voltage signal from the
ignition switch.
Selected Air Mode
The scan tool displays AUTO, Upper, Defog, Bi-Level, Heater or Defrost. Display indicates the current operating mode of the HVAC system.
Steering Wheel Controls
The scan tool displays 0-999 counts. The signal in counts as received from the steering wheel controls.
Suspension Position Sensor
The scan tool displays 0 to 5 volts. Display indicates the position of the suspension position sensor.
System Program Number
The scan tool displays 0 to 255 counts. Display indicates the commanded temperature setting.
TCS Switch
Display Off or On. Display indicates the status of the traction control switch.
Temperature Status
The scan tool displays Hot or OK. Hot is displayed when engine coolant temperature rises above 121°C (250° F). OK must be displayed to allow A/C
operation.