Aurora V6-214 3.5L VIN H SFI (2001)
Min. Htr./Def.A/C Dr.
The scan tool displays 0 to 255 counts (0 to 5 volts). The minimum travel range when driven to the stop during Recalibrate All Motors command.
Non-Overhead Lamps Relay
The scan tool displays On/Off. Display indicates the status of the overhead lamps relay.
Outside Air Temp-HVAC Sensors
The scan tool displays -40 to +60° C (40 to +140° F). The output of the ambient air temperature sensor
Outside Air Temp-Open/Short Data
The scan tool displays 0 to 255 counts (0 to 5 volts). The status of the sensor signal circuit is monitored. 0 counts indicates a short to ground, 255 counts
indicates an open circuit.
Overhead Lamps Output
The scan tool displays On/Off. Display indicates the commanded state of the overhead lamps.
Park Lamp
The scan tool displays On/Off - Display indicates the state of the Park lamp switch.
Park Lamp Relay Output
The scan tool displays On/Off - Display indicates the Commanded of the park lamp relay.
Pass. Door Jamb Sw.
The scan tool displays On/Off. Display indicates the state of the right front door jamb switch. On indicates the door is open and off indicates the door is
closed.
Power Mode Change
The scan tool displays when the vehicles power source has changed to ON, IGN, or RAP and CTD is activated.
Pressure Status
The scan tool displays Low, Normal or High. Normal must be displayed to allow A/C operation.
Progress Fault-Compressor
Defined period of time the that the compressor is active, and a change is not detected by the sensor
Progress Fault-Exhaust
The scan tool displays Active/Inactive. Display indicates a defined period of time the exhaust is active and no change is detected by the suspension
position sensor.
PROM ID
The scan tool displays a 4 digit alphanumeric number. This is the modules internal PROM identification number.
RAP Output
The scan tool displays On/Off. Display indicates the status of the RAP function.
Rear Defog Relay
The scan tool displays On/Off - Display indicates the commanded state of the rear defog relay.
Rear Fog Lamp Relay
The scan tool displays On/Off. Display indicates the commanded state of the rear lamp relay.
Rear Fog Lamp Switch
The scan Tool displays On/Off. Display indicates the state of the rear fog lamp switch.
Reverse Lamp Relay
The scan tool displays On/Off. Display indicates the commanded state of the reverse lamp relay.
Reverse Lockout Drive
The scan tool displays On/Off. Display indicates the status of the reverse lockout function.
Right AC Duct Temp-HVAC Sensors