Aurora V6-214 3.5L VIN H SFI (2001)
4. Remove the EGR valve.
5. Remove the IAC valve attaching screws (3) from the IAC valve (2).
6. Remove the IAC valve (2) from the throttle body.
7. Remove the O-ring from the IAC valve.
INSTALLATION PROCEDURE
NOTE: The IAC valve may be damaged if installed with the cone (pintle) extended more than 28 mm (1-1/8 in). Measure the distance that the valve
is extended before installing a new valve. The distance from the idle air control valve motor housing to the end of the idle air control valve pintle
should be less than 28 mm (1-1/8 in). Manually compress the pintle until the extension is less than 28 mm (1-1/8 in).
1. Install the new idle air control O-ring on the IAC valve.
2. Install the IAC valve (2) into the throttle body.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the IAC valve attaching screws (3).
Tighten
Tighten the screws to 3.0 N.m (27 lb in).
