Aurora V6-214 3.5L VIN H SFI (2001)
Instrument Panel Control Module: Service and Repair
INSTRUMENT PANEL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left sound insulator.
2. Remove the fastener (2) from the instrument panel module (IPM).
3. Rotate the IPM up and out of the instrument panel (IP) retainer.
4. Disconnect the electrical connectors from the IPM (1).
INSTALLATION PROCEDURE
1. Connect the electrical connectors to the instrument panel module (IPM) (1).
2. Install the IPM (1) to the instrument panel (IP) retainer by inserting the top tab of the module into the slot on the IP retainer and rotating down.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the fastener.
Tighten
Tighten the fastener to 2 N.m (18 lb in).
4. Install the left sound insulator.