Aurora V6-214 3.5L VIN H SFI (2001)
5. Push down flex lock button (3) and then move sliding connector locking cover (4) to the close position.
6. Install the connector position assurance (CPA) (1) to the SDM wiring harness connector (2).
7. Install the carpet pre-slit to the close position covering the SDM.
8. Install the console.
9. Install the driver and passenger seat to the original position.
10. Enable the SIR system.
11. After replacing the SDM the new SDM must be programmed into the Dash Integration Module. Refer to BCM Programming/RPO Configuration
(DIM) or BCM Programming/RPO Configuration (IPM) or BCM Programming/RPO Configuration (RIM) in Body Control Module.