Aurora V6-214 3.5L VIN H SFI (2001)
5. Route the IP module wiring harness (2) in place to secure IP module yellow connector clip to IP (3).
6. Install the IP upper trim pad.
7. Clip the IP module yellow connector (2) to IP bracket (3).
8. Install the IP module yellow connector (2) to the vehicle harness yellow connector (1).
9. Install the Connector Position Assurance (CPA) (4) to the IF module connector (2).
10. Install passenger (right) insulator panel.
IMPORTANT: After replacing a deployed or undeployed dual stage inflator module, correct disposal is required. A deployed dual stage inflator
module must be energized to ensure that both stages are no longer active. Refer to Inflator Module Handling and Scrapping for proper disposal.
11. Enable the SIR system.