Aurora V6-214 3.5L VIN H SFI (2001)
Refer to the Line Pressure Check Procedure in SI, along with the Line Pressure Specification Table shown, to determine if actual versus desired
pressures are within the values specified. The Scan Tool is only able to control the PC solenoid valve in PARK and NEUTRAL with the vehicle stopped.
This protects the clutches from extremely high or low pressures in DRIVE or REVERSE ranges.
Refer to the Line Pressure Specification Table. The pressures in the table assume a temperature of 70°C. The pressure will vary with a change in
temperature.
If the actual versus desired pressures are not within the values specified, clean the valve body and replace the PC solenoid valve, if necessary.
Check the PC solenoid valve actual versus desired pressures to verify the new PC solenoid valve is responding correctly.
Refer to the Automatic Transaxle Section of the Service Manual for the proper repair procedure.
Line Pressure Check Procedure Tools Required
J 21867
Universal Pressure Gauge Set
Important:
Before performing a line pressure check, verify that the pressure control (PC) solenoid valve is receiving the correct electrical signal from the PCM.
1.
Install a Scan Tool.
Caution:
Keep the brakes applied at all times in order to prevent unexpected vehicle motion. Personal injury may result it the vehicle moves unexpectedly.
2.
Start the engine and set the parking brake.
3.
Check for a stored Diagnostic Trouble Code (DTC).
4.
Repair the vehicle, if necessary.
5.
Check the fluid level. Refer to the Transmission Fluid Checking Procedure.
6.
Check the manual linkage for proper adjustment.
