Bravada V6-262 4.3L VIN W CPI (1994)
NOTE: Angle must not exceed 12.5 deg.
5. Install attaching screws through cover and seal to dash panel.
6. Connect electrical connectors and install steering wheel, then connect transmission linkage and battery ground cable.
Steering Wheel
STEERING WHEEL REPLACEMENT
Steering Wheel Assembly
Steering Wheel Removal
REMOVE OR DISCONNECT
TOOL REQUIRED:
^
J 1859-03 Steering Wheel Puller
1. Horn pad assembly. Refer to "Horn Switch Replacement."
2. Retainer (20).
3. Steering wheel nut (21). Note the relationship of alignment mark (A) on the steering wheel and on the steering shaft.
4. Steering wheel, using J 1859-03. Do not hammer on the puller, or damage could result to the steering column.
INSTALL OR CONNECT
^
The turn signal control assembly must be in the neutral position when assembling the steering wheel.
1. Steering wheel onto the steering shaft. Align the marks (A) on steering shaft and steering wheel.