Bravada 2WD L6-4.2L VIN S (2002)
Transmission Speed Sensor: Service and Repair
Vehicle Speed Sensor (VSS) Replacement
Removal Procedure
1. Remove the harness connector.
2. Remove the bolt (2).
3. Remove the vehicle speed sensor (1).
4. Remove the O-ring seal (3).
Installation Procedure
1. Install the O-ring seal (3) on the vehicle speed sensor (1).
2. Coat the O-ring seal (3) with a thin film of transmission fluid.
3. Install the vehicle speed sensor (1) into the transmission case.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the bolt (2).
^
Tighten the bolt to 11 Nm (97 inch lbs.).
5. Connect the wiring harness electrical connector to the vehicle speed sensor.
6. Refill the fluid as required.
