Bravada 2WD L6-4.2L VIN S (2002)
1. Install the washer hose to the vehicle.
2. Route the hose along the body wiring harness.
3. Tape the washer hose to the body wiring harness with 3 wraps of electrical tape, every 100 mm (4 in).
4. Roll carpet back into place along floor panel.
5. Reinstall rear compartment anchors.
6. Reinstall rear seat backs.
7. Reinstall right front sill plate.
8. Connect the washer hose connection at the liftgate.
9. Connect the pass-though grommet the liftgate.
10. Install the left rear quarter upper trim panel.
11. Install the rear washer hose out though the bulkhead, and seat the grommet (1).
12. Connect the rear washer hose connection (2) near the coolant tank.
