Bravada 4WD V8-5.3L VIN P (2004)
Important: Removal may require a light amount of force. DO NOT pry on the EBCM or the BPMV.
5. Remove the EBCM from the BPMV.
Installation Procedure
Important: Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
1. Install EBCM on to the BPMV.
Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
2. Install the 4 new T-25 TORX screws in the EBCM (2).
Tighten the 4 T-25 TORX screws to 5 Nm (39 inch lbs.) in an X-pattern.
3. Install the 2 electrical connectors on the side of the EBCM.