Bravada 4WD V8-5.3L VIN P (2004)
2. Disconnect the electrical connector from the mode actuator-auxiliary (1).
3. Remove the mode actuator-auxiliary (1) from the HVAC module-auxiliary.
4. Remove the retaining screws from the mode actuator-auxiliary.
INSTALLATION PROCEDURE
1. Install the mode actuator (1) to the HVAC module-auxiliary.
2. Install the screws to the mode actuator-auxiliary.
NOTE: Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
3. Connect the electrical connector to the mode actuator-auxiliary (1).
4. Install the right rear quarter trim panel.
5. Calibrate the HVAC module actuators, See: Testing and Inspection/Programming and Relearning
Mode Actuator Replacement - Console
MODE ACTUATOR REPLACEMENT - CONSOLE
REMOVAL PROCEDURE
1. Remove the floor console.
2. Rotate the console.
3. Remove the screw from the air outlet duct.
4. Remove the air outlet duct from the floor console.