Bravada 4WD V8-5.3L VIN P (2004)
7. Install the J 8614-01 onto the pinion yoke as shown.
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: If the rotating torque is exceeded, the pinion will have to be removed and a new collapsible spacer installed.
8. Tighten the pinion nut while holding the J 8614-01.
^
Tighten the pinion nut until the pinion end play is just taken up. Rotate the pinion while tightening the nut to seat the bearings.
9. Measure the rotating torque of the pinion using an inch-pound torque wrench.
Compare the measurement of the rotating torque to the measurement recorded earlier.
^
The rotating torque of the pinion nut should be 0.40 - 0.57 Nm (3 - 5 inch lbs.) greater than the torque recorded during removal.
10. If the rotating torque is not within specifications, continue to tighten the pinion nut.
^
Tighten the pinion nut, in small increments, as needed, until the torque required in order to rotate the pinion is 0.40 - 0.57 Nm (3 - 5 inch lbs.)
greater than the torque recorded during removal.
11. Once the specified torque is obtained, rotate the pinion several times to ensure the bearings have seated. Recheck the rotating torque and adjust if
necessary.
12. Install the rear steering gear crossmember.
13. Install the front propeller shaft.
14. Install the engine protection shield.
15. Inspect the axle lubricant level, and add, if necessary.
16. Lower the vehicle.
