Calais V6-3300 3.3L MFI VIN N (1990)
heat may ease the clean-up of the retainer. (Fig. 1 (B and C)).
4.
Coat all surfaces that will have adhesive applied with 3M Window Weld Primer No. 08643 or equipment. This high zinc content primer will
ensure adhesion of the cement as well as provide
some rust protection for minor paint fractures. Deep scratches of paint damage must be repaired prior to installing the new seal.
Figure 2
5.
Seal the gap between the seal retainer and the roof opening (use 3M No. 8011 Weatherstrip Adhesive or equivalent). Be sure to make the adhesive
flush with the top of the retainer as in Fig. 2(A). Allow approximately 30 minutes for this to dry before going to the next step.
6.
Apply weatherstrip adhesive (3M No. 08011 or equivalent) inside the retainer at "B" as shown in Fig. 2(B).