oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

Body and Frame|Jack > < Interior - Rattle/Buzz From I/P During Braking|Page 7735
Page 4
background image

14.

Remove two screws holding left air outlet trim plate to instrument panel, Fig. 176.

15.

Carefully pull at bottom of trim plate to release spring clips.

16.

Disconnect electrical connector for headlight switch, and remove air outlet trim plate.

17.

On vehicles equipped with sport pod, remove sport pod as follows:
a. Remove two screws on bottom of assembly, Fig. 177.
b. Remove three screws holding assembly to instrument panel.
c. Pull assembly outward and disconnect electrical connector to lighter.
d. Remove four screws holding filler to instrument panel.

18.

On vehicles not equipped with sport pod, remove left center air outlet plate assembly as follows:
a. Remove three screws holding left center air outlet assembly to instrument panel trim plate.
b. Remove air outlet trim plate by pulling carefully at bottom of plate to release spring clips.

19.

On all models, remove left and right instrument panel sound insulators.

20.

Remove two screws holding ALDL connector to instrument panel.

21.

Remove four steering column trim plate attaching screws, Fig. 178.

22.

Pull trim cover rearward and disconnect trunk release electrical connector.

23.

Remove two bolts at upper part of column and one bolt at lower part of column, then lower column.

24.

Disconnect left and right courtesy light assemblies.

25.

Remove two screws holding parking brake release handle to instrument panel.

26.

Turn handle and remove it from instrument panel.

27.

Remove three fuse block bracket to instrument panel attaching screws.

28.

Remove seven screws holding main ventilation duct to the instrument panel.

29.

Remove nut holding wiring harness clip to instrument panel.

30.

Remove screw holding glove compartment light, then slide off bracket.

31.

Remove two instrument panel attaching screws, located at lower left and right sides of panel.

32.

Remove five instrument panel attaching screws at top of instrument panel.

33.

Remove two instrument panel attaching screws at steering column support.

34.

Remove instrument panel from vehicle.

35.

Reverse procedure to install.

36.

Reactivate airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.

Body and Frame|Jack > < Interior - Rattle/Buzz From I/P During Braking|Page 7735