Cutlass L4-138 2.3L VIN A FI HP (1990)
Fuel Rail Assembly
15.
Remove the injector O-ring seal from the spray tip end of each injector, and discard.
^
If an injector was separated from the rail during removal, remove both injector O-rings.
16.
Remove injector retainer clips if necessary.
17.
Remove the fuel inlet and return tube seal retainers and tube seals.
^
Use a small screwdriver to pry out the seal retainers.
^
Discard seals and retainers.
ASSEMBLY:
1.
Lubricate new injector O-ring seals with clean engine oil, and install on the injectors.
2.
Install new injector retainer clips, if necessary.
3.
If separated from the fuel rail, install the injectors, with the electrical connector facing outward.
^
Push in far enough to engage the retainer clip with the machined slots on the rail socket.
4.
Install new fuel inlet and return tube seals and retainers.
^
Press the retainer in to contact the O-ring.
INSTALLATION:
1.
If the fuel rail was disconnected from the fuel pipes, reconnect the fuel pipes at this time.
