Cutlass V6-189 3.1L VIN T FI (1990)
additional working clearance.)
B.
Pull cable conduit out (towards the transaxle) until slider hits against adjustment stop.
C.
Release button.
D.
Re-install the valve block if removed. The T.V. cable is now in the full non-adjusted position.
3.
To set the T.V. cable, perform the following:
A.
Rotate the throttle lever to full travel position, applying no more torque than required to reach the throttle stop body.
B.
While holding the throttle lever in the full travel position, pull up on the T.V. cable to obtain three (3) additional clicks.
If it is not possible to obtain the three (3) additional clicks described above, perform the following procedures:
4.
Loosen the T.V. cable bracket nuts (2) located at the intake plenum.
5.
Move the bracket towards the throttle lever as far as it will go.
6.
Tighten the bracket nuts (2) to 10 N-m (8 lbs.ft.).
7.
Repeat steps 1 through 3 stated above.
Test drive the vehicle to verify the condftion is eliminated.
NOTE:
Anytime service is performed to the T.V. system or that the T.V. cable bracket is moved, verify that the late up-shift condition does not
exist as indicated by the "Shift Speed Chart". If condftion exists, perform steps "1" through "3" listed above.