Cutlass V6-191 3.1L VIN M SFI (1998)
7. Remove the piston seal (1) from the seal groove in the caliper housing bore using a small wood or plastic tool.
-
Inspect the caliper housing bore and the seal groove for scoring, nicks, corrosion and wear.
-
Use a crocus cloth in order to polish out light corrosion.
-
Replace the caliper housing if corrosion in and around the seal groove will not clean up with a crocus cloth.
8. Remove the bleeder valve (2) and the bleeder valve cap from the caliper (1).
-
Clean all parts in clean, denatured alcohol.
-
Dry the parts using non-lubricated compressed air.
-
Blow out all passages in the caliper housing and the bleeder valve.
INSTALLATION PROCEDURE
NOTICE: Refer to Fastener Notice in Cautions Notices.
1. Assemble the bleeder valve (2) and the bleeder valve cap into the caliper (1).
-
Tighten the bleeder valve to 13 Nm (115 in. lbs.).