Cutlass V6-191 3.1L VIN M SFI (1998)
1. Install a new gasket and new bolt grommets to the valve rocker cover. Ensure that the gasket is seated properly in the valve. groove.
2. Apply sealer in the notch on the cover. Use GM P/N 1052917 or its equivalent.
3. Install the valve rocker cover.
4. Install the valve rocker cover bolts.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
NOTICE: Refer to,Fastener Notice in Service Precautions.
5. Install the generator. Refer to Generator in Charging System.
6. Install the drive belt. Refer to Accessory Drive Belt Replacement.
7. Install the brake booster vacuum supply line.
8. Install the following components:
^
EVAP canister purge solenoid
^
Electronic ignition coil and module assembly
9. Install the rear ignition wire harness.
10. Connect the negative battery cable.