Cutlass V6-191 3.1L VIN M SFI (1998)
Installing Shaft Seal O-Ring
Lip Seal Installed On Seal Protector
Removing Or Installing Shaft Seal Retaining Ring
Install or Connect
1. Dip the new seal O-ring in clean 525 viscosity refrigerant oil and assemble onto O-ring installer 33011. "New".
2. Insert the O-ring installer J 33011 into the compressor neck until the installer "bottoms." Lower the moveable slide of the O-ring installer to
release the O-ring into the seal O-ring lower groove. (The compressor neck top groove is for the shaft seal retainer ring.) Rotate the installer to seat
the O-ring and remove the installer.
3. Dip the new seal in clean 525 viscosity refrigerant oil and assemble seal to Seal Installer J 23128-A, by turning handle clockwise. The stamped