oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

Interior - Low Pitch Rattle, Clunk/Squeak From Front End|Page 8117 > < Interior - Low Pitch Rattle, Clunk/Squeak From Front End|Page 8111
Page 1
background image

Steering Gear: Customer Interest
Interior - Low Pitch Rattle, Clunk/Squeak From Front End

File In Section: 3 - Steering/Suspension

Bulletin No.: 73-32-10

Date: April, 1998

Subject:
Low Pitch Rattle, Clunk and/or Squeak Noise Coming from Front End of Vehicle During Low Speeds (Replace Lower Control Arms or Install Rack and
Pinion Steering Gear)

Models:
1997-98 Chevrolet Malibu
1997-98 Oldsmobile Cutlass

Condition

Some owners may comment on a low pitch rattle, clunk and/or squeak noise coming from the front of the vehicle while turning and/or driving straight
ahead at low speeds, between 10-18 mph, (16-29 km/h). This noise condition is most apparent when driving over rough/spalled concrete, sharp bumps or
broken pavement. A squeak noise may also be present during front end "jounce" conditions.

Cause

This condition may be due to vibrations from the suspension damping the rough roads that are being transmitted to the steering gear assembly.

Correction

Upon proper inspection, per the procedure in Section 3 - Steering/Suspension Diagnosis in the Service Manual, one of two conditions may exist:

1.

Front Suspension Noise (rattle, clunk and/or squeak) heard while driving straight ahead and/or front end "jounce".

^

Replace both lower control arms, P/N 22606709 (left) and P/N 22606710 (right).

2.

Front Suspension Noise (low pitch rattle and/or clunk) heard while turning.

^

Install a new rack and pinion steering gear assembly, P/N 26073200.

Important:

The new steering gear may result in a slight increase in steering effort while parking.

Important:

Before changing lower control arms and/or steering gear, exhaust all other possible sources of the noise, using the Service Manual procedure.
Also inspect for the following:

^

Damaged suspension components

^

Worn control arm bushings

^

Worn strut dampener or mounting

^

Rack bearing preload (Sec: 3B1A8)

^

Loose stabilizer shaft

^

Loose wheel nuts or covers

^

Spring improperly positioned

^

Loose tie rod ends

^

Loose steering gear mounting

^

Intermediate shaft boot mispositioned

Interior - Low Pitch Rattle, Clunk/Squeak From Front End|Page 8117 > < Interior - Low Pitch Rattle, Clunk/Squeak From Front End|Page 8111