Cutlass V6-191 3.1L VIN M SFI (1998)
Fluid Line/Hose: Service and Repair
Oil Cooler Pipe Seals Replacement
REMOVAL PROCEDURE
^
Tools Required
-
J 41239-1 Cooler Pipe Seal Installer
-
J 41239-2 Cooler Pipe Seal Remover
-
J 6125-B Slide Hammer
-
J 6471 Slide Hammer Adapter
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transmission cooler lines from the transmission (1 bolt) (2).
3. Install the J 41239-1 into the cooler line seal.
4. Install the J 6125-B with the J 6471 to the seal removal tool.
5. Remove the cooler line seals using slide hammer impact.
INSTALLATION PROCEDURE
1. Install the J 41239-2 on the transmission case using the cooler line bracket bolt.
2. Install the new seal in the case bore.
3. Press the new seals in by tightening the cooler line bracket bolt until the seal bottoms out in the case core.