Cutlass Ciera L4-2.2L VIN 4 (1995)
Quick-Connect Fittings: Service and Repair
TOOLS REQUIRED
-
J37O88-A tool set. Fuel line quick-connect separator.
-
Remove or Disconnect
PROCEDURE
1. Grasp both sides of fitting. Twist female connector 1 / 4 turn in each direction to loosen any dirt within fitting.
WARNING: Safety glasses must be worn when using compressed air, as flying dirt particles may cause eye injury.
2. Using compressed air, blow out dirt from quick-connect fittings at end of fuel filter.
For Plastic (hand Releasable) Fitting
3. Squeeze plastic retainer release tabs.
4. Pull connection apart.
For Metal Fitting
3. Choose correct tool from J 37088-A tool set for size of fitting. Insert tool into female connector, then push inward to release locking tabs.
4. Pull connection apart.
CLEAN AND INSPECT
CAUTION:
If it is necessary to remove rust or burrs from the male tube end of a quick-connect fining: use emery cloth in a radial motion with the tube end to
prevent damage to O-Ring sealing surfaces.
- Using a clean shop towel, wipe off male tube ends.
- Inspect all connectors for dirt and burrs. Clean or replace components / assemblies as required.
INSTALL OR CONNECT
WARNING: To Reduce the Risk of Fire and Personal Injury:
-
Before installing a new filter, always apply a few drops of clean engine oil to the male tube end of the filter and to the fuel level meter
assembly. This will ensure proper reconnection and prevent a possible fuel leak. (During normal operation, the O-Rings located in the
female connector will swell and may prevent proper re-connection if not lubricated).
1. Apply a few drops of clean engine oil to the male tube end of the filter and of the fuel sender assembly.
2. Push connectors together to cause the retaining tabs / fingers to snap into place.
3. Once installed, pull on both ends of each connection to make sure they are secure.
