Cutlass Ciera L4-2.2L VIN 4 (1995)
thumb, push up on guide to remove guide from block Remove block from tape and let guide and sash drop to bottom of door.
6. Tape from tabs using flat-bladed screwdriver.
7. Use crank handle or run regulator motor (if electric) to remove tape from regulator.
Install or Connect
1. Cut service tape to length needed.
2. Insert tape into "fishmouth" of regulator to attach to gear. Use handle or motor (if electric) to run tape through regulator. Position end of tape to
center of access hole. Last hole on tape must fit over last tab on regulator housing. This is required for proper glass travel.
3. Tape to regulator tabs.
4. Raise guide and sash above end of tape. Install block to tape with flat end at bottom. Lower guide and snap over block.
5. Position regulator sash to lower sash and install sash bolts.
Tighten
^
Bolts to 7 N.m (62 lb. in.).
6. Masking tape from glass. Check window operation for full-up and down travel.
7. Water deflector.
Tape Drive Regulator
Tape Drive Regulator Service Parts - Electric Shown, Manual Similar