Cutlass Ciera Cruiser V6-3100 3.1L MFI VIN M (1994)
Measurement
If Installing a new IAC Valve measure the distance between tip of IAC valve pintle and mounting flange. If greater than 28 mm, use finger
pressure to slowly retract the pintle. The force required to retract the pintle of a new valve will not cause damage to the valve.
INSTALLATION
1. Lubricate the IAC valve O-ring with engine oil and install assembly.
2. Install the attaching screws and torque to 3.0 Nm (27 lb. in.).
3. Connect the electrical connector.
4. Reset the IAC valve pintle position:
^
Turn the ignition "ON" for five seconds.
^
Turn the ignition "OFF" for ten seconds.
^
Start the engine and check for proper idle operation.