Cutlass Ciera Cruiser V6-3100 3.1L MFI VIN M (1994)
Wheel Bearing: Service and Repair
Hub, Bearing & Seal
FRONT WHEEL BEARINGS AND/OR HUB
Fig. 1 Front Suspension
Hub and bearing are replaced as an assembly. Refer to Fig. 1 during service procedure.
1. Loosen hub nut with vehicle on ground.
2. Raise and support vehicle, then remove front wheel.
3. Install drive axle seal protectors. These protectors should be used any time service is performed on or near drive axle. Failure to use them
may result in interior joint or seal damage.
4. Remove, then discard hub nut and washer.
5. Remove brake caliper from support and suspend caliper from frame with a length of wire. Do not suspend caliper by the brake hose. Remove
rotor.
6. Using tool No. J-28733, or equivalent, separate hub and drive axle.
7. Remove hub and bearing attaching bolts, then shield, hub and bearing assembly and O-ring.
8. To remove factory seal, tap seal toward engine. When seal is removed from steering knuckle, cut it off drive axle using side cutters. Factory seal
is installed from engine side of steering knuckle. Replacement seal is installed from wheel side of steering knuckle.
9. Reverse procedure to install, noting the following:
a. Lubricate seal, then install using seal installer tool No. J-28671, or equivalent.
b. Tighten bolts/nuts to specifications.