Cutlass Ciera Cruiser V6-3300 3.3L MFI VIN N (1993)
Correction
Clean and repaint the affected area using the following procedure and product.
Important:
DO NOT REPLACE COMPONENTS TO REPAIR THIS CONDITION.
The exhaust system must be cold to begin this procedure.
Material Required: * Wabash Products # KB-318-HHHS, available in pints or quarts as ready to spray material (no mixing required). Call Wabash
Products, 1-800-326-7269 or 812-232-6097 for pricing and shipping information.
Procedure
On a cold exhaust system:
1.
Raise vehicle on hoist.
2.
While supporting exhaust with a transmission jack, remove the rear exhaust system hangers and lower the exhaust.
3.
Clean the affected area with a wax and grease remover, lacquer thinner or other suitable solvent.
4.
Wire brush the affected area to remove flaking paint and blow off with air.
5.
Sand the affected area with # 80 to 150 grit sandpaper to remove rust, dirt or other contaminants.
6.
Clean the affected area with a wax and grease remover, lacquer thinner or other suitable solvent.
7.
Tape off the rear lower body panels and exhaust pipes forward of mufflers to protect from overspray.
8.
Apply paint to affected area in several (6 to 8) thin coats (to prevent sags and runs) obtaining approximately 1 mil paint coverage.
9.
Raise exhaust system with jack, reinstall exhaust hangers, lower vehicle and remove from hoist.
^
Allow 30 minutes drying time.
10.
In a well ventilated area, start engine and allow to idle for up to 30 minutes until paint is cured and dry.
Important:
Some "smoking" will occur while curing the paint with the engine running.
The paint can be heated and cured while driving, but be careful not to get the exhaust system wet during the first 30 minutes.
Warranty Information
Labor
Material
Operation
Labor Time
Allowance
A6150
0.6 hr - Single Exhaust
GC
Add
0.2 hr - Dual Exhaust
GC
Important:
While the above procedure and materials are correct for vehicles from 1993 to 1998, the Labor Operation and Time Allowance only pertains to
vehicles in the Warranty period.
*
We believe this source and their equipment to be reliable. There may be additional manufacturers of such equipment. General Motors does not
endorse, indicate any preference for or assume any responsibility for the products or equipment from these firms or for any such items which may be
available from other sources.
Technical Service Bulletin # 93T77
Date: 930701
Paint - Bubbling or Blistering on Windshield Molding
NUMBER: 93-T-77
