Cutlass Ciera Cruiser V6-3300 3.3L MFI VIN N (1993)
Throttle Body: Service and Repair
Coolant Cavity Cover
Throttle body from intake plenum.
Refer to "Throttle Body Assembly."
Disassemble
1.
Coolant cover attaching screws (45).
2.
Coolant cavity cover (40) and O-ring (46). Discard O-ring.
Clean O-ring sealing surfaces.
Inspect sealing surfaces for corrosion or damage that could cause a coolant leak. Replace coolant cavity cover or throttle body if necessary.
Assemble
1.
Lubricate new coolant cover O-ring (46) with ethylene glycol antifreeze.
2.
O-ring in cavity of throttle body.
3.
Coolant cavity cover (40).
Hold cover in place.
4.
Coolant cover attaching screws (45).
Tighten
Attaching screws to 3.O Nm (27 in lb).
Install or Connect
Throttle body to intake plenum.
-
Refer to "Throttle Body Assembly."
Coolant Cavity Cover
REMOVAL:
1.
Remove throttle body assembly, see THROTTLE BODY HOUSING for procedure.
2.
Remove coolant cover attaching screw assemblies.
3.
Remove coolant cavity cover.
4.
Clean and inspect O-ring sealing surfaces, for damage and corrosion. Replace coolant cavity cover or throttle body if necessary.
INSTALLATION:
1.
Lubricate the new coolant cover O-ring with Ethylene Glycol antifreeze.
2.
Place the O-ring in the cavity of the throttle body.
3.
Position the coolant cavity cover onto the throttle body, and hold it in place.
4.
Install the coolant cavity cover attaching screws, and tighten to 3.0 Nm (27 in lb).
5.
Reinstall throttle body, see THROTTLE BODY HOUSING for procedure.
6.
Connect the negative battery cable.
IDLE LEARN PROCEDURE: Any time the battery is disconnected, the programmed position of the IAC valve pintle is lost, and replaced with a
default value. To return the IAC valve pintle to the correct position, perform the following procedure:
1.
After restoring battery power, connect the Tech 1 "SCAN" tool.
