Cutlass Supreme V6-204 3.4L DOHC VIN X SFI (1995)
edge to verify that the timing marks are opposite of each other.
7. Install a soft jaw clamping device to the left front camshaft sprockets.
8. New camshaft timing belt by routing it around sprockets and idlers.
A. Start at intermediate camshaft sprockets and work counterclockwise when looking at front of engine.
B. Make sure not to accumulate slack in belt as you work around sprockets.
9. Tensioner pulley.
A. Use a flat magnet, tape, or cup plug to hold pivot tube in pulley.
B. Install the pulley and remove the flat magnet, tape, or cup plug.
C. Start tensioner pulley bolt. Tighten tensioner pulley bolt to 15 Nm (11 ft. lbs.). Tighten tensioner pulley bolt to 50 Nm (37 ft. lbs.).
10. Install tensioner bushing into side plate, if removed.
Inspect
-
Bushing and appropriate holes to make sure they are clean. DO NOT LUBRICATE.
11. Timing belt tensioner.