Cutlass Supreme V6-3100 3.1L MFI VIN M (1994)
10.
Install bracket to body frame. Tighten bolt to 25 N.m (18 lb. ft.).
11.
Install NEW brake hose and NEW washer to caliper (routing should be the same as in Figure 2). Tighten fitting to 44 N.m (32 lb. ft.).
12.
Install NEW brake hose to pipe. Tighten fitting to 15 N.m (11 lb. ft.).
13.
Bleed brake hydraulic system following the applicable Service Manual procedures, Section 5, Brakes.
14.
Install wheel assembly.
15.
Repeat process on other side IF REQUIRED.
16.
Install Campaign Identification Label.
Installation of Campaign Identification Label
Clean surface of radiator upper mounting panel and apply a Campaign Identification Label. Make sure the correct campaign number is inserted on the
label. This will indicate that the campaign has been completed.
Owner Letter
Dear General Motors Customer:
General Motors of Canada Limited has determined that a defect which relates to motor vehicle safety exists in certain 1994-95 Buick Regal and 1994
Oldsmobile Cutlass Supreme model vehicles. The rear wheel brake hose(s) on some of these vehicle may be contacting rear suspension components.
This condition can cause the brake hose(s) to wear through, resulting in loss of brake fluid and eventual loss of vehicle braking system. If this condition
were to occur in a situation where stopping distances were minimal, a vehicle crash could occur, without prior warning.
To prevent the possibility of this condition occurring, your dealer will inspect for proper rear brake hose position. Those rear brake hoses found in the
incorrect position will be replaced with new hoses and correctly routed.
This service will be provided for you at no charge.
Please contact your GM dealer as soon as possible to arrange a service date.
If parts are required, ask your dealer for details regarding their availability. If parts are not in stock, they can be ordered before scheduling your service
date.
This letter identifies your vehicle. Presentation of this letter to your dealer will assist their Service personnel in completing the necessary correction to
your vehicle in the shortest possible time.
We are sorry to cause you this inconvenience; however, we have taken this action in the interest of your continued satisfaction with our products.