Cutlass Supreme V6-3100 3.1L MFI VIN M (1994)
2. Drain coolant.
3. Pipe bracket transaxle stud nut.
4. Pipe bracket block stud nut.
5. Loosen clamp and remove hose from dash side heater inlet.
6. Push pipe into nipple and insert special tool J 38723 into nipple to release locking tabs.
7. Pull retainer and pipe from heater inlet nipple.
Inspect
^
O-Ring sealing surface on pipe.
Adjust
^
If replacing heater inlet nipple, remove retainer from pipe and discard, as new nipple is equipped with retainer.
^
If replacing pipe, remove retainer from pipe and reinsert retainer in nipple.
^
If reusing pipe and nipple, retainer can remain in place on pipe.
Install or Connect
1. Push pipe into nipple until retainer tabs lock.
^
Pull back on pipe to check for proper engagement.
2. Hose to dash side heater inlet.
Tighten
^
Nut to 3 N.m (27 lb. in.).
3. Pipe bracket block stud nut.
Tighten
^
Nut to 3 N.m (27 lb. in.).
4. Pipe bracket transaxle stud nut.
5. Refill coolant.
6. Air cleaner and duct assembly.
Tighten
^
Bolts to 5 N.m (44 lb. in.).