Cutlass Supreme V6-3100 3.1L MFI VIN M (1994)
4. Door handle cover assembly.
5. Lock cylinder to lock rod.
6. Outside handle to lock rod.
7. Screws securing lock assembly to door.
8. Rivets securing lock module assembly to door by punching out mandrel, then using a 4.8 mm (3/16 inch) drill bit.
9. Power lock connector.
10. Lock module assembly.
Install or Connect
1. Lock module assembly in position through access hole in door inner panel. Align module to holes in door facing.
NOTICE: It is required that while performing step 2 the lock assembly be held tight against door facing while installing screws. All screws must be
driven at a 90 degree angle to door facing to prevent cross threading or stripping of screws or door lock attaching holes. It is also required to tighten
screws to specified torque of 7 N.m (62 lb. in.).
2. Screws securing lock assembly to door.
Tighten
^
Screws to 7 N.m (62 lb. in.).
3. Power lock connector.
4. Rivets securing lock module assembly to door using 3/16 inch x 1/4 inch peel type rivets.
5. Outside handle to lock rod.
6. Lock cylinder to lock rod.
Inspect
^
Lock system for proper operation.
7. Door handle cover assembly.
8. Nut and screw securing cover assembly to door.
Tighten
^
Nut to 3 N.m (27 lb. in.).
^
Screw to 2 N.m (18 lb. in.).
9. Water deflector.
10. Do or trim panel.
Sedan