Cutlass Supreme V6-3100 3.1L MFI VIN M (1994)
-
If an original design switch is installed (Figure 1), the switch WILL need to be replaced. Proceed to Step # 4.
-OR-
-
If a NEW design switch has been previously installed (Figure 2), the switch will not need replacement. Proceed to Step # 10.
4.
Disconnect negative battery cable.
5.
Disable SIR system; refer to "Disabling the SIR System" in Section 3F of the Service Manual
6.
Remove old design windshield washer/wiper switch following instructions outlined in the Service Manual.