Intrigue V6-3.8L VIN K (1998)
Antenna Extension Cable Replacement: Fixed Antenna (US6) - Removal Procedure
6. Disconnect the antenna extension cable from the fixed antenna.
Antenna Extension Cable Replacement: Fixed Antenna (US6) - Removal Procedure
7. Remove the rear seat cushion.
8. Remove the RH carpet retainer.
9. Remove the RH center pillar lower trim panel.
10. Pull back the RH side of the carpet enough to gain access to the wiring harness.
11. Remove the RH Instrument Panel (IP) insulator.
12. Remove the IP compartment.
13. Remove the radio control.
14. Cut off the visible ends of the extension cable(s) to be replaced:
-
If the antenna front extension cable is to be replaced, cut off the end which connects to the radio control; disconnect the front extension
cable from the rear extension cable along the front door hinge pillar, then cut off the end of the front cable.
-
If the antenna rear extension cable is to be replaced, disconnect the rear extension cable from the front extension cable along the front door
hinge pillar, then cut off the end of the rear cable; cut off the end which connects to the fixed antenna.
IMPORTANT: Take note of the antenna extension cable(s) routing before removal.
15. Remove the antenna extension cable(s) from the vehicle.
INSTALLATION PROCEDURE
