Intrigue V6-3.8L VIN K (1998)
Rear Door Panel: Service and Repair
REMOVAL PROCEDURE
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Trim Panel Replacement: Side Rear Door - Removal Procedure
1. Remove the rear door power window/power door lock switch.
2. Remove the door handle bezel.
Remove the door trim panel screw located behind the door handle bezel.
3. Remove the door trim panel screws located by the armrest handle.
4. Remove the door trim panel using J 38778.
5. Disconnect the electrical connectors.
6. Remove the door trim panel from the door.
INSTALLATION PROCEDURE
IMPORTANT: Discard the old door trim panel retainers and replace with new retainers before installing the trim panel.
Trim Panel Replacement: Side Rear Door - Installation Procedure
1. Install new trim panel retainers to the rear door trim panel.
2. Connect the electrical connectors.
3. Align the door trim panel retainers to the door.
4. Press the door trim panel at the retainer locations until the retainers are fully seated.
5. Install the trim panel screws.
Tighten