Intrigue V6-3.8L VIN K (1998)
Seat Cushion: Service and Repair
Seat Cushion Trim Panel Replacement - Outer
REMOVAL PROCEDURE
Seat Cushion Trim Panel Replacement: Outer - Removal Procedure
1. Remove the front seat back recliner handle.
2. Remove the screws from the seat cushion trim panel.
3. Remove the seat cushion trim panel.
Pull the seat cushion trim panel to release the two retaining clips located on each side the recliner handle hole.
4. Disconnect the power seat switches electrical connectors.
5. Remove the seat cushion trim panel from the seat.
6. Remove the six-way power seat switch, if required.
INSTALLATION PROCEDURE
Seat Cushion Trim Panel Replacement: Outer - Installation Procedure
1. Install the six-way power seat switch, if required.
2. Connect the power seat switches electrical connectors.
3. Install the seat cushion trim panel, pressing in until the two retaining clips are fully seated.
4. Install the seat cushion trim panel screws.
Tighten
Tighten the seat cushion trim panel screws to 3 N.m (27 lb in).
5. Install the front seat back recliner handle.